Forward Controls Design AR-15 TGF Trigger Guards - Winter

SKU
FCD00676
Out of stock
Forward Controls Design Winter Trigger Guard

Machined from 7075 aluminum, they do not have spring loaded detent for the front, but use a set screw like Magpul's, and a standard trigger guard roll pin in the rear.

Both versions feature a canted front edge to make rocking the magazine into the mag well easier. The winter version has as much constant/unchanged space from the trigger bow forward as possible (instead of the space inside tapering and decreasing as the trigger guard nears the receiver's front trigger guard holes). The space to the rear of the trigger bow is inaccessible for the user's finger, so it's kept small and low. Available in anodized black, desert tan, and OD green (desert tan and OD green for standard/straight TGF in 2020).

TGF is designed for use with TDP spec forged lower receivers, and fills the gap forward of the pistol grip, between the trigger guard "ears" (note that TGF will not swing down like TDP spec trigger guards).  All the sharp edges and corners have been removed.    Due to the variations and tolerances of forged receiver forgings, fitting might be required for receivers too far from TDP dimensions and tolerances. 

Lower receivers made from Cerro Forge "keyhole" forgings generally have taller trigger guard ears, as do Colt, LMT, and BCM lower receivers. 

Please note ZEV produced lower receivers appear to have shorter trigger guard ears, and these shortened ears expose a bit of the bottom of the TGF, as shown below.  This has no bearing on functionality.

More Information
Dangerous GoodsYes
Shipping RestrictionITAR/Export Restricted
FinishType III Class 2 Hardcoat Anodized
Material7075-T6 Aluminum
Weapon ModelAR-15/M-16
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
AGE VERIFICATION
Due to increased state legislation around firearms, you MUST be at least 18 years old to access our site. Are you at least 18 years old?”